Hardware - Prototype Development
Today is the prototype development for voltage regulator and motor driver circuit. Both circuits were developed on single hole board. I prefer to use a single hole board due to its flexibility to arrange component and reduce the potential of short circuit compared to strip board. Below are the pictures taken during the prototype development.
 |
| Component arrangement |
 |
| Soldering process |
 |
| Wiring process |
 |
| Measuring the output |
The voltage is quite low because the battery is not charged yet since I bought it. This measurement is to ensure that threre is an output from the voltage regulator. The output supposed to be plus minus 5V.
 |
| The voltage regulator with battery |
No comments:
Post a Comment